Qwiic/STEMMA Connector and Cable for Raspberry Pi
This Qwiic/STEMMA connector from Ozzmaker allows you to easily connect Qwiic or STEMMA enabled modules to a Raspberry Pi, without the need for soldering.
It uses a 2x3 pin female header which sits on top of the first 6 GPIO pins and breaks out the 3.3v, GND and the two I2C pins (SDA, SCL) on a 4 pin JST connector which sits on top.
Works great with the BerryGPS-IMU!
The cable is 7.87" / 20cm in length.
Package contents
- 1 x Qwiic connector
- 1 x Qwiic cable
Note: Raspberry Pi and BerryIMU are not included.
This Qwiic/STEMMA connector from Ozzmaker allows you to easily connect Qwiic or STEMMA enabled modules to a Raspberry Pi, without the need for soldering.
It uses a 2x3 pin female header which sits on top of the first 6 GPIO pins and breaks out the 3.3v, GND and the two I2C pins (SDA, SCL) on a 4 pin JST connector which sits on top.
Works great with the BerryGPS-IMU!
The cable is 7.87" / 20cm in length.
Package contents
- 1 x Qwiic connector
- 1 x Qwiic cable
Note: Raspberry Pi and BerryIMU are not included.
Description
This Qwiic/STEMMA connector from Ozzmaker allows you to easily connect Qwiic or STEMMA enabled modules to a Raspberry Pi, without the need for soldering.
It uses a 2x3 pin female header which sits on top of the first 6 GPIO pins and breaks out the 3.3v, GND and the two I2C pins (SDA, SCL) on a 4 pin JST connector which sits on top.
Works great with the BerryGPS-IMU!
The cable is 7.87" / 20cm in length.
Package contents
- 1 x Qwiic connector
- 1 x Qwiic cable
Note: Raspberry Pi and BerryIMU are not included.
